Dipl.-Ing. Michael Koch Raabestr. 43 D-37412 Herzberg Germany Tel: +49 (0)5521 854265 Fax: +49 (0)5521 854266 www.astro-electronic.de e-mail |
||
Bitte beachten Sie, dass die auf dieser Seite gezeigten Produkte ab 22.7.2014 nicht mehr erhältlich sind. |
|
Zeitschalter
mit Blink-Funktion für TELRAD Finder
Diese
Platine können Sie nachträglich in den TELRAD Finder einbauen.
Sie hat zwei Funktionen:
Der
Einbau ist einfach: Mit der beiliegenden Bohrschablone bohren Sie 5 Löcher
in die Seitenwand des TELRAD Finders (1x Taste, 2x Drehknopf, 2x Schraube).
Dann trennen Sie die Kabel von der Batterie zur LED durch und löten
die 4 Enden an die Platine an. Eine genaue Anleitung liegt bei. Der Helligkeitsregler
bleibt weiterhin funktionsfähig.
Timer and blinking circuit for TELRAD Finder This circuit fits into the TELRAD finder and has two functions: 1. The LED will switch off automatically after about 3 minutes. This means that the battery will not discharge if you forget to switch off the finder. By pressing the yellow button the LED is switched on again. 2.
You can let the LED shine continuously or blinking. You can adjust the
blinking on-time and off-time independently with the two red turnknobs.
The advantage of a blinking LED is that you can see fainter stars if the
LED is off.
Installation
is easy: Drill 5 holes into the side wall of the TELRAD finder using the
enclosed drilling template (1x button, 2x turnknobs, 2x screws). Then you
cut the cable from the battery to the LED and solder the 4 ends to the
circuit. Detailed instructions are included. The brightness regulator will
work as before.
|
LED-Zeitschalter
(ohne Blink-Funktion)
Diese
Platine können Sie nachträglich in den TELRAD Finder, in Fadenkreuz-Okulare
oder in Teilkreis-Beleuchtungen einbauen.
LED Timer Circuit (without blinking) You
can use this circuit for the TELRAD finder, for reticle illuminations or
for setting circles illuminations.
|